Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Dodge and Ram >> 2018 >> ProMaster 1500 >> Repair and Diagnosis >> Engine Mechanical >> Exhaust System >> Sensor, Exhaust Temperature >> Installation >> Exhaust Gas Temperature Sensor DPF 1/1

Exhaust Gas Temperature Sensor DPF 1/1

GC0162100Courtesy of CHRYSLER GROUP, LLC
CAUTION:

The exhaust gas temperature sensor requires care when handling and installing. The exhaust gas temperature sensor is sensitive to knocks and bending. For this reason if the exhaust gas temperature sensor has been dropped, it must not be installed as damage to the sensor may have occurred. Do not remove from packaging until ready to install. Failure to follow these instructions may result in damage to the exhaust gas temperature sensor.

  1. Install the exhaust temperature sensor 1/1 (1) and tighten to 45 N.m (33 ft. lbs.).
    GC0161796Courtesy of CHRYSLER GROUP, LLC
  2. Connect the exhaust temperature sensor wire harness connector (1).
  3. Install the EGR Cooler. Refer to COOLER, EXHAUST GAS RECIRCULATION (EGR), INSTALLATION .
  4. Connect the negative battery cable.
scientia non olet · About Mike's Workshop Manuals