Insulator, Engine Mount, Front: Removal

WARNING: This page is about a different variant/trim than selected.

Disconnect the negative battery cable.
Remove the Variable Valve Timing Solenoid (VVTS). Refer to SOLENOID, VARIABLE VALVE TIMING (VVTS), EXHAUST, REMOVAL .
Remove nut and the oil dipstick tube.
Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .

Courtesy of CHRYSLER GROUP, LLC
Remove the belly pan retainers (1) and remove the belly pan.

Courtesy of CHRYSLER GROUP, LLC
Remove fasteners (1, 2) and the generator support bracket (3).
Remove support and lower the vehicle.

Courtesy of CHRYSLER GROUP, LLC

NOTE:
Left side shown, right side similar.
Remove both left/right engine mount heat shield nuts (3) and the heat shields (4).
Remove both left/right engine mount bolts (2).

Courtesy of CHRYSLER GROUP, LLC

NOTE:
Do not use air tools to install the engine lift fixture.
Install the Engine Lift Fixture (special tool #8984B, Fixture, Engine Lifting) (1), Engine Lift Adapter (special tool #8984-UPD, Adapter, Engine Lift) (2) and the Engine Support Fixture (special tool #8534C, Fixture, Driveline Support) (3).
Raise the engine to provide clearance to remove the engine mounts.

Courtesy of CHRYSLER GROUP, LLC

NOTE:
Left side shown, right side similar.
Remove both left/right engine mount bolts (1) and the engine mount(s) (2).

Courtesy of CHRYSLER GROUP, LLC

NOTE:
Left side shown, right side similar.
If required, remove bolts (1) and the engine mount bracket(s) (2).