Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Dodge and Ram >> 2018 >> Challenger SXT Plus >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (5.7L Engine (Service Information)) >> Engine Block >> Damper, Vibration >> Installation

Damper, Vibration: Installation

WARNING: This page is about a different variant/trim than selected.
GC0144946Courtesy of CHRYSLER GROUP, LLC
  1. Position damper onto crankshaft.
  2. Using (special tool #10387, Installer, Vibration Damper), install the threaded rod (1) onto the crankshaft (2).
  3. Tighten the threaded rod (4) until it is seated to the face (3) of the crankshaft.
  4. Install the press washer, bearing, washer, and the press nut onto the threaded rod.
  5. Press the vibration damper on till seated.
    GC0143968Courtesy of CHRYSLER GROUP, LLC
  6. Install crankshaft damper bolt.
  7. Position the (special tool #10386, Holder, Vibration Damper) (2), onto the vibration damper (3).
  8. Tighten the bolt to the proper specification. Refer to TORQUE SPECIFICATIONS  .
  9. Remove the cardboard from radiator face.
  10. Install the cooling fan. Refer to FAN, COOLING, INSTALLATION .
  11. Install the serpentine belt. Refer to BELT, SERPENTINE, INSTALLATION .
  12. Refill the cooling system. Refer to STANDARD PROCEDURE .
  13. Connect the negative battery cable.
scientia non olet · About Mike's Workshop Manuals