Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Dodge and Ram >> 2018 >> Challenger SXT Plus >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Electronic Control Modules (Service Information) >> Module, Keyless Ignition Node (Kin) >> Removal

Module, Keyless Ignition Node (Kin): Removal

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Lower the steering column to the lowest position.
    GC0170469Courtesy of CHRYSLER GROUP, LLC
  3. Using a trim stick (1) or equivalent, carefully remove the instrument cluster bezel (2).
  4. Reach through the Integrated Center Stack (ICS) screen opening and disconnect the Keyless Ignition Node (KIN) electrical connector.
    GC0162393Courtesy of CHRYSLER GROUP, LLC
  5. Press on the tabs (2) and push the KIN (1) out the front of the instrument panel.
scientia non olet · About Mike's Workshop Manuals