Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Dodge and Ram >> 2017 >> Durango R/T, AWD >> Repair and Diagnosis >> Engine Mechanical >> Lubrication System >> 5.7L Engine (Service Information) >> Valve Timing >> Cover(S), Engine Timing >> Removal

Cover(S), Engine Timing: Removal

GC0144321Courtesy of CHRYSLER GROUP, LLC
  1. Remove the cooling fan module (1). Refer to FAN, COOLING, REMOVAL .
  2. Remove the serpentine belt. Refer to BELT, SERPENTINE, REMOVAL .
    GC0146185Courtesy of CHRYSLER GROUP, LLC
  3. Remove the oil pan. Refer to PAN, OIL, REMOVAL .
  4. Drain the cooling system. Refer to STANDARD PROCEDURE .
  5. Remove the lower radiator hose clamp (1) at the water pump.
  6. Remove the lower radiator hose clamp (2) at the radiator and remove the lower radiator hose (3).
    NOTE:

    It is not necessary to disconnect the refrigerant lines for A/C compressor removal.

  7. Remove the A/C compressor from the engine block and position aside. Refer to COMPRESSOR, A/C, REMOVAL .
    GC0095240Courtesy of CHRYSLER GROUP, LLC
  8. Lower the vehicle.
  9. Disconnect the CMP sensor electrical connector (4).
  10. Remove CMP sensor mounting bolt (3).
  11. Using a slight rocking motion, carefully remove the CMP sensor (1) from the timing cover (2).
  12. Check the condition of the CMP sensor O-ring, replace as necessary.
    GC0145666Courtesy of CHRYSLER GROUP, LLC
  13. Remove the upper radiator hose clamp (1) at the thermostat housing.
  14. Remove the upper radiator hose retainer (2) at the fan shroud and position the radiator hose aside.
  15. Remove the air cleaner resonator support bracket at the water pump.
    GC0146197Courtesy of CHRYSLER GROUP, LLC
  16. Disconnect the electrical connector to the coolant temperature sensor (3).
  17. Remove the heater tube retaining bolt (1).
  18. Lift the heater tube (2) out of the water pump.
  19. Check condition of heater tube O-ring, replace as necessary.
    GC0118699Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    It is not necessary to disconnect the hoses from the power steering pump, for power steering pump removal.

  20. Remove the power steering pump (1) and position aside.
  21. Remove the generator. Refer to GENERATOR, REMOVAL .
    GC0132222Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    When installing the puller tool, ensure the bolts are fully threaded through the entire crankshaft damper.

  22. Remove the crankshaft damper bolt.
  23. Install puller tool (2) and remove the crankshaft damper (1).
    GC0081770Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    It is not necessary to remove the water pump for timing cover removal.

  24. Remove the timing cover bolts and remove the timing cover.
  25. Verify the timing cover slide bushings (1) remain located in the timing cover.
  26. Clean the sealing surfaces as necessary.
scientia non olet · About Mike's Workshop Manuals