Sensor, Coolant Temperature: Installation: 3.6L
WARNING: This page is about a different car, the 2014 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.
- Apply Mopar® thread sealant with PFTE part number 04318034 to sensor threads.
- Install the sensor (1) to the cylinder head. Tighten sensor to 11 N.m (8 ft. lbs.).
- Connect the electrical connector to sensor.
- If removed, install the belly pan.
- Lower the vehicle.
- Replace any lost engine coolant. Refer to STANDARD PROCEDURE .