Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Dodge and Ram >> 2015 >> Challenger SXT Plus >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Electronic Control Modules (Service Information) >> Module, Active Damping Control >> Installation >> Installation

Module, Active Damping Control: Installation: Installation

Fig 1: Active Damping Control Module, Screws & Connectors
GC0162427Courtesy of CHRYSLER GROUP, LLC
  1. Place the Active Damping Control Module (ADCM) (3) into position and install the four ADCM retaining screws (2). Tighten to the proper SPECIFICATIONS .
  2. Install the retaining screws (2) and tighten to 9 N.m (80 in. lbs.).
  3. Connect the wire harness connectors (1) to the ADCM (3). Install the inner left rear wheel well carpet. Refer to CARPET, INSTALLATION .
  4. Connect the negative battery cable.
  5. Perform the ADCM Verification Test. Refer to STANDARD PROCEDURE .
scientia non olet · About Mike's Workshop Manuals