Diagnostic Test

1. Ignition on
2. With the scan tool, select View DTCs.
   NOTE:

   It may be necessary to drive the vehicle to meet the conditions to set this DTC, try to repeat the conditions in which the fault originally set by reviewing the Freeze Frame data.

   Is the DTC Active or Pending at this time?

   Yes 

   • Go To  2

   No 

   • Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to INTERMITTENT CONDITION .

Are any Intelligent Battery Sensor Circuit DTCs set in the Body Control module?

Yes 

• Diagnose the appropriate Intelligent Battery Sensor Circuit DTC in the Body Control module. Refer to BODY CONTROL MODULE (BCM) - DIAGNOSTIC CODE INDEX .

No 

• Go To  3

1. Verify that the correct battery is installed in the vehicle.

   Is the correct battery installed?

   Yes 

   • Replace the Intelligent Battery Sensor (IBS) in accordance with the service information.
   • Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .

   No 

   • Replace the Battery. Refer to BATTERY, AGM, REMOVAL .
   • Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .