Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Dodge and Ram >> 2013 >> Journey Crew, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Electronic Control Modules (Service Information)) >> Standard Procedure >> RF-Hub Programming

RF-Hub Programming

WARNING: This page is about a different car, the 2012 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Do not put a laptop or any wireless device (cell phones, audio devices etc.) near the top of the center console (the RKE antenna is located below the center console).

  1. After the RF-Hub have been replaced with new unit, connect the diagnostic scan tool to the Data Link Connector (DLC).
  2. Turn the ignition ON
  3. Navigate to the RF-Hub (RFH) in the "Vehicle View" of the diagnostic scan tool.
  4. Turn the ignition OFF
  5. Put all the FOBiKs used in this vehicle on the front seat away from the console.
  6. With the scan tool select: "Program ignition FOBIKs" in the Miscellaneous Functions menu and follow the instructions on the screen.
    NOTE:

    When programming a FOBIK, have it in your hand resting on the console.

  7. After all the FOBiKs have been programmed, run the "RF-Hub Replace" routine.
  8. Turn the ignition on.
  9. Turn the ignition to the OFF position, wait 30 seconds, then cycle the ignition back to the ON/RUN position.
  10. Verify that the all the FOBiKs buttons work.
scientia non olet · About Mike's Workshop Manuals