Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Dodge and Ram >> 2013 >> Durango R/T, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 515 (Electronic Control Modules (Service Information)) >> Module, Heated Seat >> Installation >> Installation

Module, Heated Seat: Installation: Installation

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Heated Seat Module, Connector & Tab
GC0082156Courtesy of CHRYSLER GROUP, LLC
CAUTION:

The Heated Seat Module mounting tab can be damaged during module removal and installation. Use care to properly align tab to prevent binding that could result in tab breakage.

  1. Install the heated seat module (3) into the vehicle.
  2. Position the retaining tab (2) with the mounting hole in the seat pan (1). Firmly apply even pressure to the module (3) until the mounting tab is fully seated.
  3. Connect the wire harness connector (4) to the heated seat module (3).
  4. Connect the battery negative cable.
  5. Check for proper heated seat system operation.
scientia non olet · About Mike's Workshop Manuals