Tire Pressure Sensor Retraining

Using a RF signal, each sensor transmits tire pressure data approximately once every minute. Each sensor's (transmitter) broadcast is uniquely coded so that the TPM module can monitor the state of each of the sensors on the 4 rotating road wheels. The TPM module automatically learns and stores the sensor's ID while driving after a sensor has been replaced..

Perform one of the following to allow the system learn the new sensor ID:

• Once the vehicle has remained stationary for more than 20 minutes, drive vehicle for a minimum of 20 minutes while maintaining a continuous speed above 20 mph (32 km/h). During this time, the system will learn the new sensor ID.
• Use the TPM-RKE Analyzer 9936, with the Scan Tool to program the RF Hub module with the tire pressure sensor ID. This is part of the TPM Diagnostic Verification Test.