Electronic Manual Temperature Control (EMTC): Notes
WARNING: This page is about a different car, the 2012 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
EMTC is not available on hybrid vehicles.
NOTE:
When installing a new HVAC module on vehicles equipped with EMTC, the Programmable Module Installation (PMI) procedure must be carried out to configure the new module to the vehicle. Refer to
MODULE CONFIGURATION
article.
The HVAC module selections include the following:
- Air inlet source (outside or recirculated)
- Blower motor speed
- Discharge air temperature (temperature blend)
- Discharge air location (defrost, panel, floor, panel/floor, defrost/floor)
- A/C compressor operation
- Rear window defroster operation
- Heated seat operation (if equipped)