Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Dodge and Ram >> 2013 >> Challenger SXT Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 1697 (Information System And Entertainment System) >> Removal And Installation >> Front Display Interface Module (FDIM) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Module configuration is only required if a new Front Display Interface Module (FDIM) is being installed.
  1. Upload the FDIM configuration information to the scan tool. For additional information, refer to Programmable Module Installation (PMI) in MODULE CONFIGURATION article.
  2. Remove the instrument panel upper finish panel by pulling straight back.
  3. Remove the 4 FDIM screws.
  4. Remove the FDIM.
    • Disconnect the electrical connector.
  5. To install, reverse the removal procedure.
    • Download the configuration information to the FDIM. For additional information, refer to PMI in MODULE CONFIGURATION article.
scientia non olet · About Mike's Workshop Manuals