Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles

NOTE: Module configuration is only required if a new ACM is being installed.

Upload the ACM configuration to the scan tool. For additional information, refer to Programmable Module Installation (PMI) in MODULE CONFIGURATION article.
Remove the middle instrument panel center finish panel. For additional information, refer to INSTRUMENT PANEL AND CONSOLE article.
Remove the 4 ACM screws.
- To install, tighten to 2 Nm (18 lb-in) (navigation).
- To install, tighten to 1 Nm (9 lb-in) (all except navigation).
Navigation
Disconnect the antenna and electrical connectors.
All except navigation

NOTE: Only carry out this step if installing a new ACM.

Remove the 2 ACM brackets.
All vehicles
Remove the ACM.
To install, reverse the removal procedure.
- Download the configuration information to the ACM. For additional information, refer to PMI in MODULE CONFIGURATION article.