Programming The Win: Procedure
CAUTION:
Read all notes and cautions for programming procedures.
NOTE:
Have the vehicle PIN readily available to enter whenever prompted before running the routine.
CAUTION:
If the PCM and WCM are replaced at the same time, the PCM MUST be programmed before the WCM.
- Connect a battery charger to the vehicle.
- With the wiTECH diagnostic application, perform the following steps:
- Select "WIRELESS CONTROL MODULE (WCM)"
- Select the "MISCELLANEOUS FUNCTIONS" tab
- Highlight "WCM REPLACED"
- Select the "Start Misc Function" button
- Select "NEXT"
- Enter the PIN when prompted.
- Select "NEXT"
- Verify that the PIN number is correct
- Once verified select "NEXT"
- Select "NEXT"
- Note On-Screen instructions and select the "FINISH" button
- Cycle ignition key twice after the successful routine completion.