Second Row Outboard

WARNING:

To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the Chrysler Mopar® Parts Catalog.

Fig 1: Screws & Second Row Outboard Seat Belt Lower Anchor

Courtesy of CHRYSLER LLC

Remove the screw (3) that secures the second row outboard seat belt lower anchor to the rear floor panel.
Remove the trim from the inside of the upper C-pillar. Refer to PANEL, C-PILLAR TRIM, REMOVAL .
Disengage the seat belt webbing and lower anchor from the seat belt opening in the upper C-pillar trim.
Remove the screw (1) that secures the seat belt turning loop to the upper inner C-pillar.
Remove the seat belt turning loop from the upper inner C-pillar.
Partially remove the trim from the front of the quarter inner panel, far enough to access the seat belt retractor (2) for removal. Refer to PANEL, QUARTER TRIM, REMOVAL .
Remove the screw (4) that secures the retractor to the lower inner C-pillar.
Disengage the retractor locator tab from the slot in the lower inner C-pillar.
Remove the second row outboard seat belt and retractor from the lower inner C-pillar as a unit.