Section 9 (3.6L - Intermittent Condition, Pcm/ECM Reprogramming Gas, Powertrain Verification Test & Pre-Diagnostic Troubleshooting Procedure)
WARNING: This page is about a different variant/trim than selected.
- Standard Procedure
- Intermittent Condition
- Pcm/ECM Reprogramming - Gas
- Pcm/TCM Flash Reprogramming
- Table Of Contents
- Section 1 - Pcm/TCM Flash Procedure
- Repair Procedure - Using WITECH™ Diagnostic Application
- Repair Procedure - Using STARMOBILE® Desktop Client
- Section 2 - Additional Pcm/TCM Replacement Procedures
- Notes
- If an NGC3 or NGC4 PCM was replaced, perform the following additional steps and/or routines:
- If a GPEC PCM was replaced, perform the following additional steps and/or routines:
- If a CVT TCM was replaced, perform the following additional steps and/or routines:
- If an EGS TCM was replaced, perform the following additional steps and/or routines:
- Step-By-Step Instructions
- Section 3 - Authorized Modification Label
- Required Tools/Equipment:
- Tech Tips And Information:
- Parts Required
- Powertrain Verification Test
- Pre-Diagnostic Troubleshooting Procedure