DTC 90E0: Lost Communication With Electronic Ignition Switch (CGW) Module: Notes
For complete wiring diagrams, refer to SYSTEM WIRING DIAGRAMS .
- When Monitored:
With the ignition on.
Battery voltage between 10 and 16 volts.
IOD fuse installed.
EIS (CGW) is configured correctly.
- Set Condition:
Bus messages not received from the EIS (CGW) for approximately two to five seconds.
| Possible Causes |
|---|
| CAN C BUS CIRCUITS OPEN OR SHORTED |
| DTCS RELATED TO BATTERY VOLTAGE, IGNITION, OR VIN MESSAGES |
| EIS (CGW) NOT CONFIGURED CORRECTLY |
| ELECTRONIC IGNITION SWITCH (CGW) MODULE POWER AND GROUND |
| ELECTRONIC IGNITION SWITCH (CGW) MODULE |
| MODULE THAT SET THE DTC |