Diagnostic Test

TEST FOR INTERMITTENT CONDITION
1. With the scan tool, record and erase DTC's.
2. Using the scan tool, perform Programmable Special Module (PSM) Reset ECU and Load Coding for vehicle application.
3. Cycle the ignition on and off three times, turn the ignition on.
4. With the scan tool, read DTC's.
  Does the scan tool display this DTC as active?
  
  Yes
  - Replace the Programmable Special Module (PSM) in accordance with the service information.
  - Perform BODY VERIFICATION TEST - VER 1. Refer to DTC-Based Diagnostics/MODULE, Body Control (BCM) - Standard Procedure
  No
  - Test Complete.