Diagnostic Test

INTERMITTENT CONDITION
1. Turn the ignition on.
2. With the scan tool, clear all DTCs.
3. Turn the Left Turn Signal on.
4. With the scan tool, read DTCs.
  Does the scan tool display active: B1643-REAR LEFT TURN LAMP CONTROL CIRCUIT LOW?
  
  Yes
  - Go to 2
  No
  - The condition that caused this symptom is currently not present. Check for an intermittent condition by inspecting the related wiring harness for chafed, pierced, pinched, and partially broken wires. Also, inspect the related connectors for broken, bent, pushed out, spread, corroded, or contaminated terminals. Repair as necessary.
  - Perform the BODY VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure .
REAR LEFT TURN SIGNAL BULB
1. Turn the ignition off.
2. Disconnect the Rear Left Turn Signal Bulb.
3. Turn the ignition on.
4. With the scan tool, read DTCs.
  Does the DTC reset?
  
  Yes
  - Go to step 3
  No
  - Replace the Rear Left Turn Signal Bulb in accordance with the Service Information.
  - Perform the BODY VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure .
(L63) LEFT TURN SIGNAL CONTROL CIRCUIT SHORTED TO GROUND
1. Turn the ignition off.
2. Disconnect the TIPM C7 harness connector.
3. Disconnect the Left Rear Tail Lamp harness connector.
4. Measure the resistance between ground and the (L63) Rear Left Turn Signal Control circuit.
  Is the resistance above 10k Ohms?
  
  Yes
  - Replace the Totally Integrated Power Module (TIPM) in accordance with the Service Information.
  - Perform the BODY VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure .
  No
  - Repair the (L63) Rear Left Turn Signal Control circuit for a short to ground.
  - Perform the BODY VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure .