Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Dodge and Ram >> 2009 >> Durango Base, 3.7 K >> Repair and Diagnosis >> Engine Performance >> System >> DTCS P2096 To P2174 >> P2123-Accelerator Pedal Position Sensor 1 Circuit High >> Possible Causes

Possible Causes

Possible Causes 
(K23) APP SENSOR NO. 1 SIGNAL CIRCUIT SHORTED TO VOLTAGE
(K23) APP SENSOR NO. 1 SIGNAL SHORTED TO THE (F855) 5-VOLT SUPPLY CIRCUIT
(K23) APP SENSOR NO. 1 SIGNAL SHORTED TO THE (F856) 5-VOLT SUPPLY CIRCUIT
(K4) APP SENSOR NO. 1 RETURN CIRCUIT OPEN
APP SENSOR
POWERTRAIN CONTROL MODULE (PCM)
WARNING: On vehicles equipped with the high voltage system, you must thoroughly read and follow all High Voltage Safety procedures. In addition, before performing any diagnostic or service procedure near a high voltage component, you must perform the High Voltage Power Down. Failure to follow these instructions may result in possible serious or fatal injury. Refer to Electrical - Engine Systems/Battery System - Warning

Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. See  DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure  .