Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Dodge and Ram >> 2007 >> Nitro SLT, AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper System & Washer System (Service Information) >> Wipers/Washers >> Wiper Module >> Removal >> Front Wiper Module

Front Wiper Module

Fig 1: Identifying Screws, Nut, Cowl Plenum, Weld Stud, Wiper Motor & Wire Harness Connector
GC0061973Courtesy of CHRYSLER LLC
  1. Disconnect and isolate the battery negative cable.
  2. Remove both front wiper arms from the wiper pivots. See REMOVAL .
  3. Remove the cowl plenum cover/grille panel from over the cowl plenum. Refer to REMOVAL .
  4. Disconnect the wire harness connector (6) for the front wiper motor (5) from the motor connector receptacle.
  5. Remove the two screws (1) that secure the ends of the front wiper module bracket to the cowl plenum (3).
  6. Remove the nut (2) that secures the front wiper motor bracket rubber insulator to the weld stud (4) located on the bottom of the cowl plenum.
  7. Remove the front wiper module from the cowl plenum as a unit.
scientia non olet · About Mike's Workshop Manuals