Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Dodge and Ram >> 2007 >> Nitro SLT, AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Anti-Theft Systems >> Vehicle Theft Security (Service Information) >> Vehicle Theft Security >> Intrusion Module >> Removal >> Intrusion Module

Intrusion Module

Fig 1: Identifying Intrusion Module , Left Inner D-Pillar, Plastic Push-In Fasteners & Body Wire Harness
GC0061950Courtesy of CHRYSLER LLC
  1. Disconnect and isolate the battery negative cable.
  2. Partially remove the trim from the inside of the left inner D-pillar (3). Refer to REMOVAL .
  3. Disconnect the take out of the body wire harness (2) from the connector receptacle on the forward-facing side of the intrusion module (1).
  4. Remove the two plastic push-in fasteners (4) that secure the module to the inner D-pillar.
  5. Remove the module from the inner D-pillar.
scientia non olet · About Mike's Workshop Manuals