Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Dodge and Ram >> 2007 >> Caliber R/T, AWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Engine & Automatic Transmission Cooling System >> Engine >> Heater-Engine Block >> Installation

Heater-Engine Block: Installation

  1. Thoroughly clean bore hole.
  2. Insert block heater assembly into bore.
  3. Install retaining clip.
  4. Connect power cord to block heater.
    Fig 1: AIR CLEANER INLET
    GC0053117Courtesy of CHRYSLER LLC
  5. Install air intake inlet.
  6. Install engine cover.
scientia non olet · About Mike's Workshop Manuals