Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Dodge and Ram >> 2007 >> Caliber R/T, AWD >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System (Service Information) >> Electrical >> Sensor-Dynamics (Esp) >> Installation

Sensor-Dynamics (Esp): Installation

Fig 1: DYNAMICS SENSOR
GC0053093Courtesy of CHRYSLER LLC
  1. Install the dynamics sensor (1) over the studs mounted to the floor pan tunnel (4).
  2. Install the two mounting nuts (2). Tighten the nuts to 9 N.m (80 in. lbs.).
  3. Connect the wiring harness connector (3) to the dynamics sensor (1).
  4. Install the shifter housing center console. Refer to INSTALLATION .
  5. Connect the battery negative cable to the battery post. It is important that this be performed properly. Refer to STANDARD PROCEDURE .
  6. Perform the Verification Test and clear any faults. Refer to STANDARD PROCEDURE .
scientia non olet · About Mike's Workshop Manuals