Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Dodge and Ram >> 2003 >> Durango Base, 4.7 N, 4WD, Part Time >> Repair and Diagnosis >> Body & Frame >> Power Windows >> Power Windows >> Diagnosis And Testing - Power Windows >> Circuit Breaker

Circuit Breaker

  1. Locate the circuit breaker in the junction block. Pull out the circuit breaker slightly, but be certain that the circuit breaker terminals still contact the terminals in the junction block cavities.
  2. Connect the negative lead of a 12-volt DC voltmeter to a good ground.
  3. With the voltmeter positive lead, check both terminals of the circuit breaker for battery voltage.

If only one terminal has battery voltage, the circuit breaker is faulty and must be replaced. If neither terminal has battery voltage, repair the open circuit from the Power Distribution Center (PDC) as required. If the circuit breaker checks OK, but no power windows operate, refer to ALL WINDOWS INOPERATIVE  .

scientia non olet · About Mike's Workshop Manuals