Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Dodge and Ram >> 2000 >> Avenger Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Body Control Modules - Except Coupe) >> System Tests >> Windshield Wiper System >> Wipers Not Working In Intermittent Mode (Sebring Convertible)

Wipers Not Working In Intermittent Mode (Sebring Convertible)

WARNING: This page is about a different car, the 2000 Plymouth Breeze, 2000 Dodge Stratus, 2000 Chrysler Sebring, and 2000 Chrysler Cirrus. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect scan tool to DLC. DLC is located above hood release handle on driver's kick panel. Select BODY CONTROL MODULE on scan tool. If scan tool operates properly, go to next step. If scan tool displays NO RESPONSE, go to BATTERY POWER TO MODULE DISCONNECT; IGNITION VOLTAGE TOO LOW; NO RESPONSE FROM BCM (BAT PWR DISCON'D); BATTERY POWER TO MODULE  under COMMUNICATIONS.
  2. Turn ignition on. Using scan tool, observe wiper voltage while moving stalk switch through all intermittent wiper positions. If voltage changes proportionally to wiper switch position, replace BCM. See BODY CONTROL MODULE (BCM)  under REMOVAL & INSTALLATION. If voltage does not change, replace multifunction switch. See appropriate STEERING COLUMN SWITCHES article.
scientia non olet · About Mike's Workshop Manuals