Compass Mini-Trip Computer (CMTC) Elapsed Time Inoperative Or Wrong
NOTE:
For connector terminal identification and wiring diagrams, see
BODY CONTROL COMPUTER - INTRODUCTION article. Perform VERIFICATION TEST VER-1A
after each repair.
NOTE:
For CMTC wiring diagram, see
ANALOG INSTRUMENT PANELS - FWD VANS article.
CAUTION:
Always turn ignition switch to OFF position prior to disconnecting any module connector.
Cycle ignition switch off, then on. Observe instrument cluster warning lights. If lights illuminate, then go off, replace Body Control Module (BCM). BCM is located with junction block under driver's side instrument panel. See Figure . If lights do not illuminate, go to appropriate VEHICLE COMMUNICATIONS article.