Test NS-SEL - No Start Test Selection Menu
NOTE:
Diagnostic Trouble Codes (DTCs) stored in Powertrain Control Module (PCM) must be repaired before using No Start (NS) tests for system diagnosis. Ensure battery is fully charged before proceeding with no start tests.
- Check for stored DTCs before using no start tests. See DTC TEST for checking for DTCs. All DTCs must be repaired before continuing.
- No start tests are recommended procedures for correcting a no start condition by the symptom. No start tests should be performed in the sequence listed. See NO START TEST SEQUENCE table.
NO START TEST SEQUENCE
| Symptom | No Start Test Number |
|---|---|
| Checking Camshaft & Crankshaft Position Sensors | NS-1A |
| Checking Secondary Ignition System | NS-2A |
| Checking Fuel System | NS-3A |
| Checking Idle Air Control Motor | NS-4A |
| Repairing A NO RESPONSE Condition | NS-6A |
| Repairing A Start & Stall Condition | NS-7A |
| Checking Engine Mechanical Systems | NS-8A |
| Repairing A No Crank Condition | NS-9A |