Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Dodge and Ram >> 1997 >> Caravan Base, 2.4 B >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - 2.4L >> Trouble Code Tests >> Test TC-25D - Idle Air Control Motor Circuits

Test TC-25D - Idle Air Control Motor Circuits

NOTE: Perform TEST TC-25A before proceeding. For connector terminal IDENTIFICATION, see CONNECTOR IDENTIFICATION DIRECTORY. For wiring diagram, see WIRING DIAGRAMS - 2.4L article.
  1. Ensure ignition is off. Disconnect connectors from Powertrain Control Module (PCM). The PCM is located between driver's side front fender and power distribution center, near battery.
  2. Check connectors for pushed out, miswired or damaged terminals. If terminals are pushed out, miswired or damaged, repair connectors as necessary. Perform TEST VER-2A. If terminals are not pushed out, miswired or damaged, go to next step.
  3. Using ohmmeter, check resistance between terminal No. 2 (Brown/White wire) on connector for idle air control motor and PCM connector terminal No. 48 (Brown/White wire). If resistance is less than 5 ohms, replace PCM. Perform TEST VER-2A. If resistance is 5 ohms or more, repair open circuit in Brown/White wire between PCM and idle air control motor. Perform TEST VER-2A.
scientia non olet · About Mike's Workshop Manuals