Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Dodge and Ram >> 1997 >> Caravan Base, 2.4 B >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - 2.4L >> Trouble Code Tests >> Test TC-19E - Injector No. 3 Control Circuit

Test TC-19E - Injector No. 3 Control Circuit

NOTE: Perform TEST TC-21A before proceeding. For connector terminal IDENTIFICATION, see CONNECTOR IDENTIFICATION DIRECTORY. For wiring diagram, see WIRING DIAGRAMS - 2.4L article.
  1. Ensure ignition is off. Disconnect connector at injector No. 3. Injector No. 3 is the third injector back from front (timing belt end) of engine. It may be necessary to remove air intake plenum for access to connector at injector No. 3.
  2. Using ohmmeter, check resistance between electrical terminals on injector No. 3. If resistance is 10-16 ohms, go to next step. If resistance is not 10-16 ohms, replace injector. Perform TEST VER-2A.
  3. Turn ignition on. Using scan tool, actuate Auto Shutdown (ASD) relay. Using voltmeter, check voltage at terminal No. 2 (Dark Green/Orange wire) on connector for injector No. 3.
  4. If voltage cycles from high voltage to low voltage, go to next step. If voltage does not cycle from high voltage to low voltage, repair open circuit in Dark Green/Orange wire between injector No. 3 and ASD relay. Perform TEST VER-2A. The ASD relay is located in power distribution center at driver's side front corner of engine compartment, near battery.
  5. Turn ignition off. Disconnect connectors from Powertrain Control Module (PCM). The PCM is located between driver's side front fender and power distribution center, near battery.
  6. Using ohmmeter, check resistance between ground and PCM connector terminal No. 7 (Yellow/White wire). If resistance is less than 5 ohms, repair short to ground in Yellow/White wire between PCM and injector No. 3. Perform TEST VER-2A. If resistance is 5 ohms or more, go to next step.
  7. Using ohmmeter, check resistance between terminal No. 1 (Yellow/White wire) on connector for injector No. 3 and PCM connector terminal No. 7 (Yellow/White wire). If resistance is 5 ohms or more, repair open circuit in Yellow/White wire between PCM and injector No. 3. Perform TEST VER-2A. If resistance is less than 5 ohms, replace PCM. Perform TEST VER-2A.
scientia non olet · About Mike's Workshop Manuals