Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Dodge and Ram >> 1996 >> Stealth Base, Standard >> Repair and Diagnosis >> Engine Performance >> Engine Controls - Adjustments >> Throttle Position (TP) Sensor >> TP Sensor Adjustment >> Diamante (W/Traction Control)

Diamante (W/Traction Control)

  1. Disconnect TP sensor connector. Install Test Harness (MB991348 ) between TP sensor and harness connector. Turn ignition on. Using external voltmeter, measure TP sensor output voltage between terminals No. 2 and 4. See Figure . If voltage is not .58-.69 volt, go to next step.
  2. Remove throttle body. Loosen TP sensor mounting bolts. Rotate TP sensor clockwise to increase output voltage or counterclockwise to decrease output voltage. Tighten TP sensor mounting bolts. Install throttle body. Ensure no trouble codes set during adjustment of TP sensor.
scientia non olet · About Mike's Workshop Manuals