Test 12A - Faulty Electro/Mech Inst Cluster Warning LT Id

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION in this article. For wiring diagrams, see WIRING DIAGRAMS in this article.

CAUTION: Always turn ignition off prior to disconnecting or connecting any module connector.

NOTE: A base Electro/Mechanical Instrument Cluster (MIC) has only 3 gauges.

If vehicle is equipped with a base MIC, go to TEST 12B. If vehicle is equipped with a premium MIC and CHECK GAUGES light is on at all times, go to TEST 12D . If vehicle is equipped with a premium MIC and CHECK GAUGES light is not on at all times, go to next step.

Using DRB, actuate sequential light test. If sequential light test does not pass, stop actuation test and go to TEST 12C . If sequential light test passes, stop actuation test, identify faulty warning light, and perform test as indicated. See WARNING LIGHT TEST DIRECTORY.

WARNING LIGHT TEST DIRECTORY

Defective Warning Light

Perform TEST

CHECK ENGINE

⁽¹⁾

Door Ajar

TEST 13A

Liftgate Ajar

TEST 43A

Low Washer Fluid

TEST 44A

Low Fuel

⁽²⁾

⁽¹⁾	See appropriate G - TESTS W/ CODES article in G - TESTS W/ CODES TABLE.

⁽²⁾	Go to step 3).

G - TESTS W/ CODES

Model		Article No.
Caravan & Voyager
2.5L		TESTS W/CODES - 2.5L TBI
3.0L		TESTS W/CODES - 3.0L
3.3L GAS		TESTS W/CODES - 3.3L GASOLINE
3.3L CNG		TESTS W/CODES - 3.3L CNG
3.8L		TESTS W/CODES - 3.8L
Town & Country 3.8L		TESTS W/CODES - 3.8L

Ensure gas tank has more than 3 gallons in it. If fuel light is not on at all times, replace Body Control Module (BCM). Perform TEST VER-1B . If fuel light is on at all times, turn ignition off and disconnect BCM connectors. Turn ignition on. If fuel light is still on, replace MIC. Perform TEST VER-1B. If fuel light is off, replace BCM. Perform TEST VER-1B.