Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Dodge and Ram >> 1982 >> Rampage Base, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Electronic Fuel Control >> Removal & Installation >> Duty Cycle Solenoid >> Removal

Duty Cycle Solenoid: Removal

  1. Remove 2 duty cycle solenoid retaining screws and gently lift solenoid from air horn. See Figure. Remove anti-rattle spring, 2 retaining screws and idle solenoid from carburetor.
  2. Remove 2 wide open throttle cut-out switch mounting screws (if equipped). Mark location for proper assembly. Remove harness mounting screws and open retaining clip. Remove wires from connector and thread through clip.
scientia non olet · About Mike's Workshop Manuals