Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2023 >> Pacifica Hybrid Pinnacle >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Electronic Control Modules (Service Information)) >> Module, Park Assist (PAM) >> Removal And Installation >> Park Assist Module >> Removal

Park Assist Module: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the trim from the right quarter inner panel to access the Park Assist Module (PAM), which is located to the rear of the C-pillar and above the right rear wheel housing. Refer to PANEL, QUARTER TRIM, REMOVAL AND INSTALLATION .
    GC0177893Courtesy of CHRYSLER GROUP, LLC
    1 - PAM
    2 - Fasteners
    3 - Body Wire Harness Connectors
  3. Disconnect the body wire harness connectors from the PAM connector receptacles.
  4. Remove the fasteners that secure the PAM to the right quarter inner panel.
  5. Remove the PAM from the vehicle.
scientia non olet · About Mike's Workshop Manuals