Fold Stow Module (FSM): Installation

Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.

• Install the stow and go module engaging the rear tabs first before engaging the front tab on the module to the seat.
• Unstow the 60 percent 3rd row seat assembly.

When the seat is replaced or the module is updated or replaced, perform the following calibration procedures using the scan tool: 

• Calibrate Full Recline
• Calibrate Stow
• Write Left Rear Seat Position
• Write Right Rear Seat Position