Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2023 >> 300 C >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Electronic Control Modules (Service Information) >> Module, Anti-Lock Brake System (Abs) >> Installation

Module, Anti-Lock Brake System (Abs): Installation

  1. Clean any debris off the mating surfaces of the Hydraulic Control Unit (HCU) and Antilock Brake System (ABS) module.
    NOTE:

    Do not lubricate the ABS module seal.

    GC0170191Courtesy of CHRYSLER GROUP, LLC
  2. A new seal (1) must be installed to properly seal the ABS module (2); DO NOT REUSE ANY ABS MODULE SEALS  .
    GC0170199Courtesy of CHRYSLER GROUP, LLC
  3. Align and install the ABS module (1) to the HCU (2).
    GC0170098Courtesy of CHRYSLER GROUP, LLC
  4. Install and securely tighten the ABS module to HCU mounting fasteners (3).
  5. Connect the Antilock Brake System (ABS) module wire harness connector (5).
  6. Install the washer fluid reservoir. Refer to RESERVOIR, WINDSHIELD WASHER, INSTALLATION .
  7. Install the front fascia. Refer to FASCIA, FRONT, INSTALLATION .
scientia non olet · About Mike's Workshop Manuals