Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2022 >> Pacifica Hybrid Pinnacle >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Electronic Control Modules (Service Information)) >> Module, Radio Frequency (RF Hub) >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Partially remove the headliner to access the Radio Frequency Hub Module (RFHM) located at the center rear. Refer to HEADLINER, REMOVAL AND INSTALLATION .
  3. Disconnect all of the electrical connectors at the RFHM.
    GC0177331Courtesy of CHRYSLER GROUP, LLC
  4. Remove the fasteners (1) and remove the RFHM from the vehicle.
scientia non olet · About Mike's Workshop Manuals