Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2022 >> Pacifica Hybrid Pinnacle >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Electronic Control Modules (Service Information)) >> Module, Power Inverter (PIM) >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Move the drivers front seat to the full forward position.
  2. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
    GC0188574Courtesy of CHRYSLER GROUP, LLC
  3. Remove the fasteners (2) and module cover (1) to gain access to the Power Inverter Module (PIM) (3).
    GC0188573Courtesy of CHRYSLER GROUP, LLC
  4. Disconnect the wire harness connector (3) from the PIM (1).
  5. Remove the fastener (2) from the PIM.
  6. Remove the PIM the vehicle.
scientia non olet · About Mike's Workshop Manuals