Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2022 >> Pacifica Hybrid Pinnacle >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Electronic Control Modules (Service Information)) >> Module, Power Inverter (PIM) >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the Power Inverter Module (PIM) in the vehicle.
    GC0188573Courtesy of CHRYSLER GROUP, LLC
  2. Install the PIM mounting fastener (2) and tighten to the proper torque specification. Refer to TORQUE SPECIFICATIONS  .
  3. Connect the wire harness connector to the PIM connector receptacle (3).
  4. Install the PIM cover and remaining fasteners and tighten to the proper torque specification. Refer to TORQUE SPECIFICATIONS  .
  5. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
scientia non olet · About Mike's Workshop Manuals