Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2022 >> Pacifica Hybrid Pinnacle >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Electronic Control Modules (Service Information)) >> Module, HVAC >> Removal And Installation >> Rear >> Installation

Removal And Installation: Rear: Installation

WARNING: This page is about a different variant/trim than selected.
GC0177624Courtesy of CHRYSLER GROUP, LLC
  1. Position the HVACR module (2) to the housing.
  2. Install and securely tighten the two HVACR module to housing screws (1).
  3. Connect the HVACR module wire harness connector (3).
  4. Install the right rear quarter trim panel. Refer to PANEL, QUARTER TRIM, REMOVAL AND INSTALLATION .
  5. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
  6. Initiate the Actuator Calibration function using a scan tool. Refer to STANDARD PROCEDURE .
scientia non olet · About Mike's Workshop Manuals