Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2022 >> Pacifica Hybrid Pinnacle >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Electronic Control Modules (Service Information)) >> Module, Fuel Pump Control >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different variant/trim than selected.
GC0170603Courtesy of CHRYSLER GROUP, LLC
  1. Position the Fuel Pump Control Module (FPCM) to the forward part of the left rear wheel housing.
  2. Install and tighten the fasteners (1) that secure the FPCM to the left rear wheel housing.
  3. Connect the body wire harness connector (2) to the FPCM connector receptacle.
  4. Install the trim onto the left rear quarter panel. Refer to PANEL, QUARTER TRIM, REMOVAL AND INSTALLATION .
  5. Connect the negative battery cable.
scientia non olet · About Mike's Workshop Manuals