Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2022 >> Pacifica Hybrid Pinnacle >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Electronic Control Modules (Service Information)) >> Module, Electronic Shift (ESM) >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Apply the parking brake.
  2. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
    GC0177333Courtesy of CHRYSLER GROUP, LLC
  3. Remove the Integrated Center Stack (ICS) (1). Refer to MODULE, INTEGRATED CENTER STACK (ICSM), REMOVAL AND INSTALLATION .
    GC0178080Courtesy of CHRYSLER GROUP, LLC
  4. Remove the four Electronic Shift Module (ESM) bolts (2) from the ICS (1).
    GC0188576Courtesy of CHRYSLER GROUP, LLC
  5. Release the four tabs (1, 2, 3, 4) retaining the ESM to the ICS.
  6. Remove the ESM from the ICS.
scientia non olet · About Mike's Workshop Manuals