Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2022 >> Pacifica Hybrid Pinnacle >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Electronic Control Modules (Service Information)) >> Module, Active Noise Cancellation (ANC) >> Removal And Installation >> Removal And Installation - Module >> Installation

Removal And Installation - Module: Installation

WARNING: This page is about a different variant/trim than selected.
GC0177988Courtesy of CHRYSLER GROUP, LLC
  1. Position the amplifier (1) to the instrument panel carrier frame. If amplifier (1) and bracket were separated install the four fasteners to retain the amplifier (1) to the bracket.
  2. Install and securely tighten the amplifier bracket to instrument panel carrier frame bolts (2).
  3. Connect the wire harness connectors to the amplifier.
  4. Install the hush panel and the hush panel fasteners.
  5. Install the glove box. Refer to GLOVE BOX, INSTRUMENT PANEL, REMOVAL AND INSTALLATION .
  6. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
scientia non olet · About Mike's Workshop Manuals