Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2019 >> Pacifica Touring Plus, Gas >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Collision/Avoidance >> Electronic Control Modules (Service Information) >> Module, Power Liftgate Control (PLGM) >> Removal And Installation >> Installation

Removal And Installation: Installation

GC0177899Courtesy of CHRYSLER GROUP, LLC
  1. Position the power liftgate control module to the rear quarter panel for installation.
  2. Insert the alignment mounting tab (1) into the locating slot on the inner quarter panel.
  3. Seat the PLGM against the panel, verifying that the rear alignment mounting tabs (2) are engaged to the panel.
    GC0178017Courtesy of CHRYSLER GROUP, LLC
  4. Connect the wire harness connectors (2) to the PLGM (1).
  5. Install the right rear quarter trim panel. Refer to PANEL, QUARTER TRIM, REMOVAL AND INSTALLATION .
  6. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
scientia non olet · About Mike's Workshop Manuals