Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2019 >> Pacifica L, Gas >> Repair and Diagnosis >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Electronic Control Modules (Service Information) >> Module, Anti-Lock Brake System (Abs) >> Removal And Installation >> Removal

Removal And Installation: Removal

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
    GC0177720Courtesy of CHRYSLER GROUP, LLC
  2. Remove the washer solvent fill tube mounting bolt (2), and remove the fill tube from the vehicle.
  3. Disconnect the antilock brake system (ABS) electrical connector (1).
  4. Remove the four antilock brake system (ABS) module to hydraulic control unit (HCU) mounting bolts (3).
  5. Carefully separate the ABS module from the HCU.
  6. Remove the ABS module from the vehicle.
scientia non olet · About Mike's Workshop Manuals