Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2018 >> 300 C >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Electronic Control Modules (Service Information) >> Module, Instrument Panel Cluster >> Installation

Module, Instrument Panel Cluster: Installation

WARNING:

Wait two minutes for the airbag system reserve capacitor to discharge before beginning any airbag system or component service. Failure to do so may result in accidental airbag deployment, personal injury or death.

GC0170880Courtesy of CHRYSLER GROUP, LLC
NOTE:

If the instrument panel cluster has been replaced, the replacement instrument panel cluster should be programmed with the correct mileage. Verify the correct mileage via WiTech/Scan Tool.

  1. Position the instrument panel cluster into instrument panel opening.
  2. Connect the instrument panel cluster wire harness connector.
    GC0170911Courtesy of CHRYSLER GROUP, LLC
  3. Tilt the instrument panel cluster forward, install and securely tighten the upper and lower fasteners (1 and 3).
    GC0170882Courtesy of CHRYSLER GROUP, LLC
  4. Position the steering column shroud gap hider (4), and press into place.
  5. Install the steering column opening cover. Refer to COVER, STEERING COLUMN OPENING, INSTALLATION .
  6. Install the two small instrument panel trim inserts (3).
  7. Position the upper hood (2) on the instrument panel (1), and press into place engaging the clips that secure the hood.
  8. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
scientia non olet · About Mike's Workshop Manuals