Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2017 >> Pacifica Hybrid Premium >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Electronic Control Modules (Service Information)) >> Module, Body Control (BCM) >> Removal And Installation >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect and isolate the negative battery cable.
  2. Remove the steering column opening cover. Refer to COVER, STEERING COLUMN OPENING, REMOVAL AND INSTALLATION .
    GC0177484Courtesy of CHRYSLER GROUP, LLC
  3. Remove the two lower Body Control Module (BCM) (1) retaining bolts (2).
    NOTE:

    There are no upper mounting bolts. The BCM clips into the upper portion of the bracket.

  4. Reposition the BCM until the BCM connectors are visible.
  5. Disconnect the wire harness connectors from the BCM.
  6. Remove the BCM from the vehicle.
scientia non olet · About Mike's Workshop Manuals