Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2017 >> 200 LX, Eng CD ED8 >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Electronic Control Modules (Service Information) >> Module, Anti-Lock Brake System >> Removal

Module, Anti-Lock Brake System: Removal

  1. To replace the ABM, the ICU assembly must be removed. Refer to INTEGRATED CONTROL UNIT (ICU), REMOVAL .
    GC0081323Courtesy of CHRYSLER GROUP, LLC
  2. Remove the four screws (1) attaching the ABM (2) to the HCU.
    GC0081324Courtesy of CHRYSLER GROUP, LLC
    CAUTION:

    When removing the ABM from the HCU, be sure to completely separate the two components (approximately 38 mm (1.5 inches)) before removing the ABM. Otherwise, damage to the pressure sensor or pump motor connection may result, requiring HCU replacement. Do not to touch the sensor terminals on the HCU side or the contact pads on the ABM side as this may result in contamination and issues in the future.

  3. Separate the ABM (1) from the HCU (2).
scientia non olet · About Mike's Workshop Manuals