Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 2016 >> 200 LX, Eng CD ED8 >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Electronic Control Modules (Service Information)) >> Module, Transmission Control >> Removal >> Removal

Module, Transmission Control: Removal: Removal

WARNING: This page is about a different car, the 2015 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position vehicle on a suitable hoist with the transaxle in neutral. Refer to HOISTING, STANDARD PROCEDURE .
  2. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  3. Raise the vehicle enough to gain access to the left front wheel.
  4. Remove the left front wheel. Refer to REMOVAL .
  5. Through the opening rearward of the suspension strut, remove the lower bolts holding the TCM to the transaxle located below the power brake booster.
  6. Lower the vehicle.
  7. Remove the engine cover.
    Fig 1: Identifying Wire Connector Lock To TCM
    GC0159257Courtesy of CHRYSLER GROUP, LLC
  8. Disengage the lock (1) holding the wire connector to the TCM.
  9. Separate the wire connector from the TCM.
  10. Remove the bolts holding the top of the TCM to the transaxle.
  11. Separate the TCM from the vehicle.
scientia non olet · About Mike's Workshop Manuals